Best Washing Machine Repair Abilene, TX
Washer won’t spin? Won’t drain? Shaking violently mid cycle? Appliance Repair Solutions repairs front load and top load washers across Abilene, with same-day appointments available when scheduling permits. Call us to get a technician on the schedule.
Common Washer Problems We Fix
Won’t Drain
Usually a clogged pump, a kinked drain hose, or a coin or sock caught in the pump itself.
Won’t Spin
Often a worn drive belt, a failed lid switch or door latch not signaling the machine it’s safe to spin, or a broken motor coupler on some top load models.
Shakes or Walks During the Spin Cycle
Almost always unbalanced load feet that need leveling, or worn suspension springs and shocks on front load washers.
Won’t Start at All
A tripped thermal fuse, a bad door latch switch, or a control board issue.
Leaves Clothes Wet at the End of the Cycle
Usually a partial drain issue or a lid switch not fully engaging, which stops the final spin from running at full speed.
Most of these are a specific part replacement — a belt, a switch, a pump — not a sign the washer is done for, which is why we diagnose before we quote.
Brands We Repair
Whirlpool, Samsung, LG, GE, Maytag, Kenmore, Speed Queen, and Electrolux, front load, top load, and stacked units.
Repair or Replace?
Washers typically last 10 to 13 years. Most common repairs, belts, switches, pumps, cost well under half the price of a new unit, so repair is usually the smarter choice unless the motor or control board fails on an older machine. We’ll tell you honestly if that’s the case for yours.
Washing Machine Repair Cost
Minor repairs run $120 to $180, mid-range $180 to $350, and major repairs like a motor or transmission $350 or more. We confirm your exact price before starting any work.
Abilene’s Hard Water and Your Washer
Abilene’s water runs about 14 grains per gallon, classified as very hard, per the city’s own water utility. Over time this causes mineral buildup inside the water inlet valve, which can restrict water flow or cause a washer to fill slowly or not at all. It’s one of the first things we check on a no-fill or slow-fill complaint here.